Shane,
If you note, there is nothing to be done with the RF Probe or the
frequency counter probe in that part of Alignment and test, so you can
go on with the Assembly Part II - you will need to frequency counter
probe for Alignment and Test Part II.
The RF Probe is used only for troubleshooting, so ideally, you would not
need to use it at all.
Do assemble the voltage probe and test it as indicated. If you messed
up that assembly too, yes, you can go back and complete the testing of
it after building another one.
73,
Don W3FPR
On 4/19/2014 7:41 PM, Lane wrote:
Hi,
I'm doing a K2 build, and was doing good till I got to the RF and freq.
probe assemblies. The part 1 tests (power up, encoder, relays) worked fine.
However, things came to a halt at the RF probe and freq. counter assembly,
mainly for lack of details in the instructions and my on-the-job training,
and so I messed those up.
I am wondering if I can continue w/ the part 2 assembly till I find new
parts or must I do the audio amp and tone generator tests, keyer, s-meter
alignment, and bargraph current test first, before starting part 2
assembly. I.e. Can I go back and do the tests after starting part 2
assembly?
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
