Do you have a Dummy Load? By transmitting into a DL, you will eliminate or confirm the presence of Common Mode Current, or any Antenna related problems. You also have the DMM, you can check for Voltave drop.
Best of luck. ((((73)))) Milverton. On Friday, April 25, 2014 11:50 AM, Martin <[email protected]> wrote: Elecrafters, >the K3 all of a sudden shut down twice during my vacation/portable >operation. I thought i had identified the problem by tightening a loose >wire in a 220V-outlet of my /p home. > >Now it shut down a third time (i believe the refrigerator turned on the >same moment) and this seems to be a tough one. > >The display shows 12V ERR on transmit , the power will not go above 12 >Watts and when i set it above 12 Watts i see 12V ERR , CHECK CIRCUIT >BREAKER. The Fan runs continuosly at mid-level. > >Where to start? The only gear for measuring is a DMM here. > >BTW: The Switcher PSU delivers rock solid 13.8 Volts. >There is no way to reload the Firmware right now, i have no cable here. > > >-- > >Ohne CW ist es nur CB... >______________________________________________________________ >Elecraft mailing list >Home: http://mailman.qth.net/mailman/listinfo/elecraft >Help: http://mailman.qth.net/mmfaq.htm >Post: mailto:[email protected] > >This list hosted by: http://www.qsl.net >Please help support this email list: http://www.qsl.net/donate.html >Message delivered to [email protected] > > > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
