Slava,
If you are using a microphone input for data modes, adjusting the mic
gain input for the data mode interface will affect the mic gain with
your microphone. You will probably find this annoying.
The usual arrangement is to configure voice modes to use the front- or
rear-panel microphone input, as appropriate for your microphone, with
the mic gain level set properly for the mike, and then to configure Data
modes to use Line In, with the Line In level set appropriately for data
mode input. The Line In level and the microphone input level are
independent, so adjusting the Line In level for data modes has no effect
on microphone input levels, which is not the case if you use a
microphone input for data modes.
If you use a sound card for voice keying, you can use the same sound
card for Data modes. You would configure MIC+LIN to be on for voice
modes and off for Data modes. By controlling the microphone input level
to the sound card when you use it as a voice keyer, you can set things
up so the Line In level that works for data modes is also the correct
setting for voice keying in voice modes. You don't need separate sound
cards or interfaces for Data vs. voice modes.
73,
Rich VE3KI
W2RMS wrote:
Hi Don, list!
I wanted to ask you if it would be possible to make a cable for the Signalink
USB box \
to connect to the K3's 8-pin front side mic connector? I have the Signalink box
that \
i'm using with my Yaesu 857D but i want to also try it with the K3. The K3's
rear \
line-in is currently taken by my audio stuff. Line out is free for now.
I see that RigBlaster has an option of using K3's 8-pin, so i'm sure Signalink
should \
be able to use that as well, right? If all the necessary pins are there i could
make \
up a CAT5 (or even 6) cable with RJ-45.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
