Thank you I have still to order the Amp, it was just something I was curious on.
________________________________ From: Tighe Kuykendall <[email protected]> To: [email protected] Sent: Friday, May 9, 2014 2:49 PM Subject: Re: [Elecraft] KPA500 - LED Alignment I believe the manual says to use a straight edge or ruler to gently push against them to align the LEDs. That's what I did and mine are all fairly well aligned. Tighe NK4I On 5/9/2014 2:34 PM, Harry Yingst wrote: > ________________________________ > From: Don Wilhelm <[email protected]> > To: Harry_Yingst <[email protected]>; [email protected] > Sent: Friday, May 9, 2014 2:29 PM > Subject: Re: [Elecraft] KPA500 - LED Alignment > > > Harry, > > Remove the front panel enclosure and tilt the LEDs until they are > aligned to your satisfaction, then put the front panel metalwork back > on. They will stay aligned. > > 73, > Don W3FPR > > -- Tighe Kuykendall NK4I | www.NK4I.com | Follow Me on Twitter: @NK4I ARRL Life Member, NAQCC #6467 ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
