I assembled my XG1 with the LEDs pushed in as far as the notch and they
look fine.
73 de David G4DMP
G-QRP 11046
In message <[EMAIL PROTECTED]>, Chris Page
<[EMAIL PROTECTED]> writes
I am building the XG1 receiver test oscillator and wonder if somebody
can please tell me if the three leds should be seated flush on the
PCB?
When I insert them, I see a notch in each lead which causes them to
stop about a quarter of an inch above the board.
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
