Don,
no i didn't install the jumper block. I'm not even sure if i still have it.
I transmitted only for very short periods touching all 3 transistors. I
felt only one of them getting warm.
So i need to find the jumper block first before i proceed the testing.
Thank you for the reply.
Am 13.05.2014 01:28, schrieb Don Wilhelm:
Martin,
I have to ask since you did not mention it -- did you install the PA
jumper block after removing the KPA3? If not, you need to do that.
As for operating the transistors in the Low Power PA getting warm - one
should *never* operate the K3 in transmit with that bottom cover
removed. The cover serves as a heat sink. Hopefully you have not
already destroyed those transistors.
73,
Don W3FPR
On 5/12/2014 5:53 PM, Martin wrote:
Elecrafters,
a little while ago i had an issue with loss of rf-power.
I thought i had found the problem. I hadn't.
Symptom now:
Power out only about 3 Watts.
I removed the 100W-PA, changed the Menue to 'not inst'.
With TUN PWR set to 12W i can achieve about 2.5W .
Only 1 of the 3 Transistors on the low-Power PA gets warm during
(short) transmissions with the bottom cover removed.
There are 2 RD15HVF1 and 1 RD06HHF1. How can i check if a transistor
is defective?
--
Ohne CW ist es nur CB..
73, Martin DM4iM
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
