Joe,
Since the call is both sent and logged without the "/", I would believe
it is some condition in N1MM causing that behavior, and has nothing to
do with the KX3.
Check the N1MM documentation (or ask on the N1MM forum) to see if the
"/" character is used as an "escape" character. If it is, then entering
two of them would be necessary to actually send and log the '/'.
73,
Don W3FPR
On 5/21/2014 3:05 PM, Hans J Rasmusen OZ7BQ wrote:
Group,
Have been using the KXUSB cable to key my KX3 from the N1MM logger with the KY
commands. That setup works fine, however during a recent trip as OZ7BQ/P, I
discovered, that my call was send as OZ7BQP. Same thing happens when I logged a
station like W1AW/0, it was logged as W1AW0.
The problem can be solved by typing 2 slashes e.g. OZ7BQ//P, but the final log
must then be filtered before use and uploading. But what is the significance of
the slash? and is there as way around the problem?
73 de OZ7BQ, Hans Joergen (Joe).
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
