Thanks, Ed. Sounds like good advice -- and I have that tool :-)
Phil W7OX
On 5/28/2014 11:59 AM, Edward R Cole wrote:
I know not what a MAB board is, but I bought pcb's from ExpressPCB and
cut them using a dremel cutoff wheel run against a metal ruler to
keep a straight line. Comes out very neat. The clue is to allow some
space on the board for cutting. For little projects this works out
cheaper.
I made TR boards with RF sensing ckt as example and my five band LP
filter for the amplifiers I built. Those were large boards (5.5x9
inch) so cutting was required.
73, Ed - KL7UW
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
