My approach to this was to use my band decoders to drive a 4P relay and use the relay contacts to drive filters, antenna switching, and "an add circuit" so if 2 of the relays were on the same band a piezo device that emits a tone as a warning of both radios being on the same band. My 2 radio band decoder is HB but the same idea could be implemented with a commercial units.
Mike W9RE >My station consists of two K-3's, each with a dedicated legal limit amplifier and SteppIr antenna. To minimize interference between bands I am >using Array Solutions Bandpass filters. However, if both rigs accidentally wind up on the same band I run the risk of overloading the front >end of the opposite rig and damaging the receiver (which I've done once...). Does anyone have a way of taking the band data information and >disabling transmit capability on both rigs if they are on the same band? How are others using SO2R avoiding same band transmission and >subsequent receiver damage? Anyone have any experience with the Array Solutions AS-RXFEP front end protector? >Thanks, >Jeff Larimore >K0RG ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
