Dave,
Put a dummy load on the KX3 the next time you try that - it is going
into transmit.
You have nothing connected to ACC2 - no voltage, no closed circuit. That
means the voltage at ACC2 IO is LOw since there nothing applied to that
input inside the KX3 - it is just a floating input. Sooo, when you
select LO=PTT in the menu, it asserts PTT on the KX3 - just as you told
it to do.
73,
Don W3FPR
On 6/2/2014 12:00 AM, David Patino wrote:
When going through the menus, if I try scrolling through the options
for ACC2 IO and I get to LO=PTT, the radio freezes. I have to remove a
battery to get it to shut down.
Nothing is plugged in to the ACC2 jack. I'm on MCU 1.87 and DSP 1.28
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
