I bought two of these at Dayton to interface a K3 to a six position coax relay/switch. Works fine. Two notes: 1. I've heard that chopping off an end of a VGA cable to go to the K3 may not work, as some VGA cables are missing certain wires that are needed for the K3 interface. I was able to find a naked VGA connector to use with four conductor plus shield wire. 2. I had hoped to mount the BCD-14 in a plastic project box, 4x2x1 roughly. But the board is about 2.25" x 2.5", so it won't fit in such boxes. Apparently it was intended for the larger, older style aluminum miniboxes. Not having one of those in stock, I used mounting tape to stick it to the top side of the coax relay switch. 73 - Jim K8MR In a message dated 6/4/2014 1:40:25 P.M. Eastern Daylight Time, [email protected] writes:
On 6/4/2014 2:55 AM, ray.fallen wrote: > To avoid list clutter, feel free to reply off-list. Some of us might be interested in the comments, which we won't see if the replies are off-list. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
