I'd start by checking ALL wire connections. Be sure you have fuse block connected properly for your input voltage and proper fuses are installed.
Call Elecraft first thing tomorrow for assistance. Good luck! Mine showed no high voltage at first. Found a shorted by-pass cap (tiny SMD type) on board near the high voltage socket and removed it. No problems since! Sent from my iPhone ...nr4c. bill > On Jun 8, 2014, at 9:40 AM, Jorge Mejia <[email protected]> wrote: > > Hello list members > > I just finished putting together a KPA 500 which seems to be having problems. > When I turn on and try to run the voltage test, the “HV” button does not > respond …. the led’s bar graph indicate 100 W and I can’t turn it off from > the front panel switch, I have to use the one on the back, neither can I > hear the fan discharging the caps. when switched off from the back. Has any > of the list members experienced this situation? > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
