Following the advice in the manual, I was using my K3 to monitor
the audio while I set the TX EQ in my new KX3. I had the KX3 at
5 watts into a dummy load and was receiving a strong signal
through the outside 20M wire beam. I discovered I could use the
P3 display of the signal to make sure I was getting power in the
speech frequencies most responsible for intelligibility. It was
quite useful when combined with listening to the audio. The
result is also getting good on-air audio reports.
73 Bill AE6JV
-----------------------------------------------------------------------
Bill Frantz | Concurrency is hard. 12 out | Periwinkle
(408)356-8506 | 10 programmers get it wrong. | 16345
Englewood Ave
www.pwpconsult.com | - Jeff Frantz | Los Gatos,
CA 95032
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
