Hi Doug: I use a similar technique in suspending my antennas. I thought I would add some do's and don'ts. Like don't forget copper will stretch. I use 1 gallon paint buckets full of dirt for about 10# of weight on the pulleys. I suspend the rope in a tree yoke or a limb close to the trunk to minimize sway. Be sure there is pleanty of travel for wind storms.
The ends of the antenna are 'hotter' than the feed point so I like to clear the end of the antenna and the tree with at least 8' of rope. If I have a middle support I use a yard arm of at least 4'. If you are using an antenna like a G5RV, Windom, or zepp that uses a portion of the feed line as a match, don't forget that portion will be radiating too so keep it vertical and away from the tree. I have found pine and eucalyptus trees to be the worst for parasitic absorption but I think that is largely a function of the volume of sap and water so the wetter the more loss and the further away you want to keep the antenna. 73, Fred, AE6QL , -----Original Message----- >From: Doug Person via Elecraft <[email protected]> >Sent: Jun 25, 2014 8:03 PM >To: [email protected] >Subject: Re: [Elecraft] RF in the Trees [OT] > >The best trick I've found in dealing with moving trees is running the >line through a pulley down to a weight that is heavy enough to keep the >things reasonably taught. The trees can move all the want and the line >just rides on the pulleys. > >Doug -- K0DXV > > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
