Kevin,
If you have moved the USB connection from connector to connector, check
your USB port assignment in Control Panel. Sometimes a different com
port is assigned to USB to serial adapters unless the same USB port is used.
73,
Don W3FPR
On 6/27/2014 7:46 PM, Kevin wrote:
Thus far I have found a few of the problems. I needed an FT232R
driver. Now the Winkey can drive the K3 just fine. N1MM on the other
hand cannot seem to run the K3 at all. While the USB connection is on
COM 4 the serial port between the keyer and the laptop does not work
on COM 1. I am not sure what changed since I last had this all
working. Any suggestions for getting N1MM to drive my K3? I may need
to reboot a few more times; this is a windows machine after all :)
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
