My SSB signal on 50 MHz is excessively wide and causing problems for
other users therefore I am seeking any assistance in curing the problem.
Adjusting the mic gain or the comp level has no effect on signal width.
The power supply voltage is stable and only varies by 100mV from standby
to full output. Examining the signal using the internal 2 tone test
revealed severe IMD at full output but dramatically cleaned up when the
power was reduced to 50W ( -3dB from peak).
I would appreciate any guidance on where to look next or if anyone has
experience of this what effected a cure.
73
Peter
G3SMT
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
