I've tried it both ways, and as I said, I did have it working before the
firmware update. So here's the oddity:
My headset is the Heil that I bought from Elecraft for the K2. It should
NOT need bias as far as I know. I just checked the MIC SEL and when I
have it on FPL, I do have the .bIAS. However, since I thought it didn't
need it, I did change the jumper in the RRC-1258 MkIIs to turn off the
bias. Could that be the problem?
Thanks Don.
On Sun, 27 Jul 2014, Don Wilhelm wrote:
Does your rear panel microphone need bias? If so do you have the bias set
ON?
73,
Don W3FPR
On 7/27/2014 6:50 PM, Hisashi T Fujinaka wrote:
I had a bit of trouble getting my mic audio working initially, but with
Brandon's help it was working. After updating my firmware it's back to
having no audio. I can change MIC SEL to FP and still run the K3
directly, but with it set to rP I don't get any audio at all.
Anyone else have this problem and have a fix? I'll have to call Brandon
tomorrow to figure out what all the steps are to get tx audio working. I
forgot to write them down.
--
Hisashi T Fujinaka - [email protected]
BSEE(6/86) + BSChem(3/95) + BAEnglish(8/95) + MSCS(8/03) + $2.50 = latte
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
