I am guessing I have mis-set some menu-settable parameter and I am looking for advice as to which one I might have mis-set so I can solve the following problem:
I am finding that I must set my KX3 receive a few hundred hertz higher than the actual frequency on which a station says he is transmitting so that I achieve natural sounding voice on receive. When I do that, the other station says my voice pitch is too low. ( So he corrects, then I correct, and we chase one another up the band. ) The same behavior occurs on CW operation. The error seems to increase with operating frequency as shown in the following table: In LSB receive WWV 05.0 megahertz carrier zero beats at approximately 05.000 133 In LSB receive CHU 7.335 megahertz carrier zero beats at approximately 07.335 190 In LSB receive WWV 10.0 megahertz carrier zero beats at approximately 10.000 250 In LSB receive WWV 15.0 megahertz carrier zero beats at approximately 15.000 384 Thanks for any suggestions; for now I am back to studying the operator's manual :) Jerry AB3SX -- View this message in context: http://elecraft.365791.n2.nabble.com/KX3-Need-Advice-Xmt-Rcv-frequencies-differ-but-RIT-turned-off-tp7592042.html Sent from the Elecraft mailing list archive at Nabble.com. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
