On your filter setup in the K3 utility, set Freq Offset to zero to start. Set bandwidth to 13, and check "FM Enable".
Also make sure that the FM filter really IS in slot 1, and that it is properly seated. 73, and good luck Guy K2AV On Sat, Aug 23, 2014 at 9:25 PM, Chris Meagher <[email protected]> wrote: > I have just started using 2 metres FM on my K3 #685. > The receive audio is rough and distorted, it sounds as if its being > clipped. > > The FM Inrad filter is .in slot 1 and FL1 is showing. > > By comparison, my Yaesu FT3000 and FT817 are qute undistorted on the same > signals > K3 SSB audio is fine. > Can anyone assist as it is not pleasant to listen to. > > Chris > VK2ACD > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
