Yes, use the .001 uF (marked 102) at C167.
Yes, you will have to bend the leads straight out and then form them
again at a right angle to fit the hole spacing.
Those yellow capacitors are also monolythic, and yes, they do not look
like the picture.
73,
Don W3FPR
On 8/30/2014 5:06 PM, Lane wrote:
Another post here since I'm sure support is closed till Tuesday and I'm
hoping to make some progress over the long weekend.
Pg 51, the very last step, is the install of C167 (.001 uF, "102").
Appendix A shows a "more or less" photo of this capacitor.
I can't locate this capacitor, but then, I may have it and it may not look
like the one in the photo.
There are some smaller capacitors remaining that are yellow (as opposed to
red in the photo) marked "102" on one side, and "K1J" on the other side.
The other oddity is that they don't look "monolithic" as described in the
appendix (they are small), nor do they match the outline on the board (but
then, the step does say to bend the leads). But this one would require an
extreme amount of bending because the holes are quite far apart in C167.
Or should it be about the same size as the 103's and 104's?
(and not very good with meters)
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
