You did the right thing using spectrogram to align the filters -- the values in the manual are really only a rough guide for those who don't have access to more advanced alignment methods such as spectrogram.
73, Matt VK2RQ > On 2 Sep 2014, at 10:13 pm, Gareth - M5KVK <[email protected]> wrote: > > K2 serial 03885 fitted with KSB Rev C board. > > When I installed the KSB2 board recently, I went through the process of > setting up the BFOs as per the KSB2 manual. However, I just downloaded > Spectrogram and went through N0SS's procedure for setting up the filters. > > Most of the adjusted settings were within 2-300Hz of those in the manual > (all on the higher side), but a couple were moved quite a bit. I'm > interested in others' experiences in this area. > > The outliers were USB FL2 which needed to be 500Hz higher and USB FL3 which > needed to be 700Hz higher. > > The main issue when looking with Spectrogram was that the USB spectrum was > far too bassy when the BFOs were set as per the manual. > > Regards > > Gareth - M5KVK > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
