Jim, Remove any convenient screw and put an internal tooth #4 solder lug under it to serve as a bonding point for the P3 enclosure.
Jim, K9YC will likely point out the "pin 1" problems and may offer additional suggestions.
73, Don W3FPR On 9/2/2014 8:16 PM, Jim Miller wrote:
Still would like to bond the P3.
______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
