Well, my KX3 is an early model that predates the point at which this mod was phased into production. I understand that the transverter module uses a separate SMA jack; my question is, while using the transverter, could there be leakage out the HF/6m antenna on the BNC jack that may be picked up by the 2m antenna on the SMA jack? Or is the BNC jack disconnected during transverter operation in a way that would prevent any such leakage?
73, Matt VK2RQ On 12 Sep 2014, at 1:00 am, Wayne Burdick <[email protected]> wrote: > This mod, which was phased into production long ago, only pertains to the > HF-6 meter antenna jack (BNC). It has no impact on the 2-meter module, which > uses the SMA jack. > > 73, > Wayne > N6KR > > > On Sep 11, 2014, at 6:49 AM, Matt VK2RQ <[email protected]> wrote: > >> For early model KX3, there is a mod kit for the BNC connector which added >> extra filtering to reduce weak signal interference on VHF/UHF. Is this mod >> recommended if the 2m transverter is installed in the KX3? Will it cause >> interference to itself on 2m without the mod? >> >> 73, Matt VK2RQ >> ______________________________________________________________ >> Elecraft mailing list >> Home: http://mailman.qth.net/mailman/listinfo/elecraft >> Help: http://mailman.qth.net/mmfaq.htm >> Post: mailto:[email protected] >> >> This list hosted by: http://www.qsl.net >> Please help support this email list: http://www.qsl.net/donate.html >> Message delivered to [email protected] > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
