John,
Thanks for the tip.
I have a hard time filtering the F.O.D. on the KX3 Yahoo group. I'll go
back and look there too.
I have set the DLY and finally got it where I can tolerate the key
clicks, but the DLY is set to about 0.20 - basically, it only clicks at
the end of transmit.
I *did* notice that even with my MON turned to 0 I still hear key clicks
in my headphones (I have been wearing headphones the entire time I've
been testing). I hear them as the rig stops transmitting.
Joel - W4JBB
On 9/13/14, 6:12 AM, John Oppenheimer wrote:
Good morning Joel,
Using 2.19. Same VFO B click with DLY = 0.00 and a little B side only
tone ring at the end of the transmission. Increasing DLY to 0.06
eliminates the clicks. My hunch is the same DSP pipe delay I mentioned
in yesterday's Yahoo KX3 list QSK email.
Not sure what the VFO B offset dependent frequency ring at the end of
the transmission is.
John KN5L
On 09/13/2014 05:42 AM, Joel Black wrote:
With my KX3 terminated into a dummy load, split and dual watch active,
VFO B 1 - 5.3 kHz up or down from VFO A, filter set to 450 Hz and
centered, I am getting key clicks on VFO B. NB and NR are off.
Does anyone else notice this or is this an issue with my rig? If it's
me, what on *Earth* have I done to cause this?
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
