I don't use FlDigi, but do use a variant of WinPSK. Set up a regular split using
the "B" VFO by double tapping A->B to copy everything to B. Turn on "Split" and
dial in the desired offset using the "B" VFO. If you need to check your TX freq,
hold the "REV" key.
On 9/13/2014 7:02 PM, Ron Schwartz wrote:
This may be a simple question, but how does FLDigi run wide (>2.5Khz) split
with the K3?. The waterfall does not allow the transmit frequency to be locked
further than the sound card bandwidth from the receive frequency. FYI, I do not
have the K3 sub-receiver installed. I presume some variation of the RIT/XIT
controls, the VFO B control, and/or FLRig needs to be used, rather than using the
transmit ‘Lk’ on the waterfall.
Thanks, Ron
K2RAS
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
