I ordered the 2 M module for a KX3 with automatic ATU (for the HF bands).
In assembling it into the KX3, I followed all the instructions, ticking
off each item. Did the set up as in the front of the instruction
manual. Display shows 2M frequencies when 2M band is selected. Power
meter shows 3 W output when xmit button pressed. However nothing
received. Set the XG3 to a 2 M frequency and tuned the KX3 passed that
frequency, but nothing heard. Also fired up my 2 M rig, but no signal
from that heard.
Not sure where to go next.
Incidentally, the label on the shield was affixed 180 degrees to the
illustration in the instruction manual. I caught that before powering
the rig.
73
Kevin
VK3DAP / ZL2DAP
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
