I would like to assign a macro that loads a frequency range then begins a scan for 20m CW with a PF key. I believe I have a workable macro but when I assign it to a PF key it does not run.
I did the following; 1. Assigned a frequency to VFO A (14000.000) and VFO B(14070.000) and mode = CW to memory position 20 in the KX3. 2. Wrote a macro (macro 1 labeled SCAN 20) in the KX3 utility as follows , MC020;SWH10; this should set the frequency for VFO A and B to the value in memory 20 then execute the SCAN button. 3. The macro works if I execute it with the utility, that is the frequency gets set and the SCAN begins. 4. I saved and wrote the macros to the KX3 with the utility. 5. If I assign it to PF1 by selecting MACRO X in the menu, then pressing 1 to indicate Macro 1 then press PF1 to assign the macro then clear the menu. If I press PF1 the VFO B space displays the macro name ( SCAN 20) but it does not change the freq or start the scan. I got the above procedure from Cady's book at page 67. Any idea what I am doing wrong? I have MCU version 01.87 and DSP 01.28 Tnx for your help. Jim - W9JFB -- View this message in context: http://elecraft.365791.n2.nabble.com/Difficulty-assigning-a-macro-to-PF1-key-tp7593167.html Sent from the Elecraft mailing list archive at Nabble.com. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
