The uC 04.86 FW REVS is the firmware revision number. From this screen
the VFO B knob should cycle through the config parameters and the VFO A
knob will cycle through the values available for the selected parameter.
From the FW REVS screen, if rotate the VFO A knob clockwise a little,
it should change to something like "d1 02.83" which is the DSP firmware
revision. I am curious if it will do this, but not change the frequency
when you exit the menu.
Mike
KI0HA
On 9/19/2014 11:00 PM, Ron Wetjen wrote:
When I go into CONFIG the display reads
uC 04.86
FW REV5
Turning VFO B doesn't change the display (and turning VFO A doesn't
change the frequency).
Checked to make sure the VFO LOCK wasn't engaged ... they weren't.
The knobs and buttons all seem to be working.
Thoughts on what to check?
Ron, WD4AHZ
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com
