KX3 firmware rev. 2.23 (with DSP rev. 1.30) enables the use of DUAL RX (dual
watch) even with RX SHFT set to 8.0 kHz in the menu. RX SHFT=8.0 can help
optimize the KX3's performance in the presense of large signals or power supply
noise. Shifting the RX may also help in CW mode with dual watch enabled,
reducing audible keying artifacts.
NOTE: On any band where dual watch is turned on with RX SHFT set to 8.0, the
normal +/- 15 kHz dual-watch VFO A-to-B separation becomes -7/+23 kHz. But the
KX3 will, in all cases, automatically turn off dual watch if the VFO separation
exceeds the limits.
Firmware files and instructions can be found here:
http://www.elecraft.com/KX3/KX3_software.htm
73,
Wayne
N6KR
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
