Kevin, VK5KS has met exactly the same problem with the encoder, as I did. Even flush,flush cutting of the leads did not solve the problem due to a nearly imperceptibly slight bend of the control board. The solution is to slide down an extremely thin sheet of plastic (1 x1 inch) down between the front board and the control board, at the very place where the encoder is sitting. With a bend of 1/8 inch to the top, the sheet will not slide further down. Simple Simon did it again.
73 OZ5RB ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
