Dummy question...
I've got a K2 serial c5500 added the KSB2 module I have a Yaseu mic
MH-31 (No additional pre-amp fitted) will to do the SSB test and
alignment with it... however the K2 is going to someone who uses an ICOM
mike, type unknown. (Yes will need to know if need to add pin 2 for a
pre-amp...checking)
Anything that might be very different between them from those in the
know that would make alignment with one irrelevant for the other?
I'm pretty sure I will have to wire differently on the unit for the
inital mike and the final one (bit of a pain ho hum), apart from the
jumpers and details listed P17/18 in the KSB2 manual.
http://www.elecraft.com/manual/ksb2%20manual%20rev%20G.pdf
Or anyone suggest suitable tests just to make sure it is all working
fine? I could think a PTT and/or an up/down break out board and switches
might be worth doing?
72/73
Dom
M1KTA
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
