Thanks, joe. I must have missed it. Vic k2vco/4x6gp
> On Oct 9, 2014, at 10:35 PM, Joe Subich, W4TV <[email protected]> wrote: > > > See the K3 & KX3 Programmers Reference for the MN command - > specifically MN023. You will also need to check the MP command > for the specific states but something like MN023;MP001;MN255; > should enable the KAT3 and MN023;MP000;MN255; should bypass the > KAT3. Note I have not verified the specific MP values. > > 73, > > ... Joe, W4TV > > >> On 2014-10-09 2:56 PM, Vic Rosenthal K2VCO wrote: >> I am pretty sure that there is no way to tell the K3 to bypass or enable >> the ATU in a macro command except by simulating the button press. Am I >> correct? >> >> What I want to do is make my "amplifier on" and "amplifier off" macros >> bypass the ATU when the amp is on but enable it when the K3 is directly >> connected to the antenna. Right now they just adjust the power output. >> >> The simulated button presses are not a good solution because you can't >> tell whether the tuner is off or on. > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
