I had a bit of a problem installing the 144 board in the KX3 I built actually the nut on the FET dropped off ,, I installed and removed the unit several times making sure the routing of the cables I checked with Elecraft on the OK to use a drop of epoxy on the nut and they suggested I send the KX3 back and allow them to do a full install and set up
wild that was an offer I couldnt refuse the install of the trransverter was going well with no problems and I sure can recommend the upgrade,,, it fits nice and the small coax connectors popped right into place does anyone think any other manufacturer of ham gear would act in this manor anyone interested in a DEM 144 verter and a kenwood 850 Oh it will be interesting to see how well the thing works as I am 200 Ft from some very dirty 150 Mhz pagers,,, does effect the FM portion of 2 meters but pretty clean at 144.2 Bob K3DJC ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
