Connection power =RTS
Connection power is the *real problem* ... set it to NONE.
Setting power on either RTS or DTR unless you need it (and
it is not needed with the K3) sets those lines "on" or "keyed".
73,
... Joe Subich, W4TV
microHAM America
http://www.microHAM-USA.com
http://groups.yahoo.com/group/microHAM
support e-mail: [email protected]
On 2014-11-14 12:57 PM, Gene wrote:
I don't know what is the real meaning of "rig control" but all I want to
do is have the K3 go to the freq. that is shown on the Dx list when I
click it.
Joe, w4tv suggested to the K3Menu: PTT-KEY set to OFF which I did.
I then set the following on the AClog rig settings:
Connection power =RTS
Ratio polling rate =500ms
Sellected TEST Button, polling rig button came on and K3 reponded.
Click "DONE" button at bottom. (NOT end test).
The K3 now will go to the Freq/Call selected from the DX list.
Thanks to all that responded.
73 for now,
Gene W2BXR
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
