Hi Tex, Almost. One leg of the Y cable is very short so you'll need a serial extension cable. There's a good drawing from SteppIR that shows how the Y cable connects to the multiple devices. Not specifically the K3 but any transceiver. E-mail me directly if you need a copy. k2mk at comcast dot net
Change the K3 config setting: CONFIG:AUTOINF to Auto 1 Of course you'll need the transceiver tracking option on the SteppIR controller and on the SteppIR transceiver setup screen set: MODE = KENW Din should match your current K3 and PC baud rate. The Y cable leg that normally goes to the transceiver will go to the P3 serial input and then the P3 serial output will go to the K3. 73, Mike K2MK pkhjr wrote > Want my steppir to track my K3, is the Y cable from steppir all I need? I > have the KPA500, P3 and KAT500 if that makes any difference. My log > program is HRD. Just got my steppir up last week......WOW. > > Thanks > > 73 Tex > ka5y -- View this message in context: http://elecraft.365791.n2.nabble.com/K3-w-Steppir-tp7594726p7594732.html Sent from the Elecraft mailing list archive at Nabble.com. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com