This happened to me not on a K3 but in a headphone conector on a mixing
board. but the same connectors. when the tip came off the
connector the tip was attached to a pin that extended trough the ring
a sleve. so what was left inside the mixer was not so deep down the
hole. with a flashlight and very fine long needle nose pliers I was
able to grab it and pull it out. no damage done.
David Moes
President: Peterborough Amateur Radio Club.
[email protected]
VE3DVY, VE3SD
On 11/17/2014 16:56, Oli, DL1OLI wrote:
Hello,
a friend of mine, also a Ham, bought his new K3 some weeks ago. He is still
leaning all the functions, but has a Problem.
He lost the tip of then 1/4" connector of his More-key in the K3 rear connector,
After removing of the 1/4" (6.3mm) plug from his K3 he noticed that the tip is
missing and still in the Connector in the K3.
Has anyone a good idea, how to remove this without destroying the connector?
vy 73
Oli
DL1OLI/AJ4UR
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
