Johnny,
That is too low. Check the value of R24, R9, R27, R11 and R10. Check
carefully for any solder bridges.
You might also want to try new batteries in your DMM and try reversing
the leads on your DMM just in case its polarity is reversed from normal.
73,
Don W3FPR
On 11/30/2014 9:11 AM, Johnny Siu wrote:
Hello KX1 builders,
The construction of KX1 runs all ok up to page 54. However, the resistance check
for Q4 base and collector, Q5 base only give 5.6k resistance towards ground
instead of >10k as mentioned in the manual.
Please advise whether this is still ok. I would like to make sure that before
going to alignment & test - part III.
73
Johnny VR2XMC
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
