In the case of the K3, the FSK mode uses DSP-generated IF frequencies in
the 15 kHz range for the Tx, and simultaneously creates audio tones at
the selected pitch-pair.
In AFSK mode, the radio requires that you supply audio to a Mic
connector or the Line In connector. The AFSK Tx filter may optionally
be employed, but its use is not required and with later versions of DSP
code is probably of marginal utility.
In the case of the KX3, the tones are generated at baseband.
73,
Lyle KK7P (who emphatically agrees these products are SDRs
On 04/12/14 18:20, Joe Subich, W4TV wrote:
The K3 does not generate AFSK internally. AFSK is only transmitted
in response to external audio.
But that is exactly how SDR architecture transmitters do generate FSK.
The only difference from what is popularly called AFSK is that the
tone starts as digital sine waves.
The ones may be a bit higher pitch than one normally expects from
AFSK, but they are still audio tones.
(As the K3 uses an I/Q structure, you could, theoretically, generate
the two tones as positive and negative tones at the same frequency,
but the problems with handling the DC crossover means that it is
unlikely that anyone would do that.)
In case it is not clear, I consider both the K3 and KX3 to be SDR
designs.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
