Bud,
Are you using a microphone connected to the computer - so the same audio
path is used for the microphone and the WAV file output?
If you prefer a microphone connected directly to the K3, then you will
have to set the K3 to MIC+LINE and plug the soundcard output to the K3
Line In jack.
Adjust the soundcard output to adequately drive the K3 ALC meter (you
can do that in TX TEST so no signal is transmitted). Drive the ALC
meter to the same level as you get from the microphone - it should be 5
to 7 bars.
73,
Don W3FPR
On 12/11/2014 4:42 PM, Bud Governale wrote:
When I hit a function key in N1MM the correct wav file plays as heard thru the
computer speakers.
However the K3 (in SSB mode) does not transmit.
Any suggestions?
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
