Wes,
Are you certain you had all the desired parameters set in the K3 when
you stored the M1-M4 per band memories? I find that they do save the
mode, frequencies, filter settings and antenna selection that you have
requested.
I don't know about your Split Macro and the LOCK functions or the RX
antenna because I have not tried those in my setup.
73,
Don W3FPR
On 12/11/2014 12:44 PM, Wes (N7WS) wrote:
Mea Culpa. Although I have the latest (I think) pdf K3 manual, some
of my research used the printed (and now out-of-date) manual that came
with my radio. I now understand the difference between "NOR" and
"Band-Sel".
However, that doesn't negate all of my concerns. The manual states
for example, that antenna selection is remembered. Perhaps that
applies to units with the built-in tuner, but it sure doesn't remember
the state of the RX antenna selection.
Other parameters that I believe should be memorized and recalled are
ATT, PRE, LOCK, FIL and probably others. In other words I would like
to be able to recover to a previously recorded state.
Now, let's say I use my "Split" macro that locks VFO A, and sets VFO B
up 1 KHz and goes into Split mode, while there I fiddle with the
Filter selection. If in M1, Split is off, VFO A = X, VFO B = Y, a FIL
is selected and normalized and Lock is off I would like to get this
all back by a press of M>V and M1. As it stands, the VFOs will revert
okay but will still be locked and the filter will be what ever it was
before.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
