To the group - closeout / lesson learned concerning the "HI CUR" warning.
>From Don W3FPR I contacted Elecraft support, and sorted things out. They asked me to confirm the tightness of the LPA screws on the bottom of the rig - I did that and they were secure. In the process of disconnecting everything to turn the rig upside down I realized the ground connection was quite loose. They also asked my to run the TX Calibration (5watt and 50watt) using the K3 utility. A few months back I had the inkling that it had been several years since doing that, but never followed-up. So I ran it and reported the results to Elecraft support. He (Howard) said the readings looked good and stated that running the cal check may have corrected the issue as I've had no repeat of the HI CURRENT warning. So I've now got a clean health check and am good to go, but will keep my eyes open. I also realized I was a little behind on updating my firmware; took care of same. Thanks all, Bruce / KE1CY ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
