Hi, I have a new K3, well, maybe 4 months old now... I noticed that the CW Speed knob, and the Filter Width knob have become noticeably sloppy in their mounting holes, as compared to the other knobs of the same type.
There is perhaps 1/8 inch of play at the end of both knobs. This is as measured by grasping one of the knobs gently pulling it left or right. The shaft feels like it is becoming loose in the encoder. The power and shift knobs on the face do not have this level of play in them, they have about 1/2 the amount. Originally these knobs all felt the same. Is this a sign of impending failure, or just a sign of use? I am assuming from the feel and look of the failure, that it is not the knob that is the issue, but the encoder shaft. The knobs feel exactly as new if I press them in to change functions, they just seem loose in the encoder mounting while handling them. If I turn the filter width too fast, it skips, is this normal? These are the two knobs I use the most. I am quite careful in handling the radio, so it is not caused by my over stressing the knobs in their mounts. I treat them gently all the time. Any thoughts? -- Thanks and 73's, For equipment, and software setups and reviews see: www.nk7z.net for MixW support see; http://groups.yahoo.com/neo/groups/mixw/info for Dopplergram information see: http://groups.yahoo.com/neo/groups/dopplergram/info for MM-SSTV see: http://groups.yahoo.com/neo/groups/MM-SSTV/info ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
