I tried to get on the OK DX RTTY contest this weekend using my K3. I used N1MM+ with MMTTY and configured MMTTY as usual. Hit the TX button in MMTTY, the K3 went into transmit mode with no output! I'm using FW version 5.01 on the K3. I eventually resolved the problem, but don't know the reason for it! What happened is this: in MMTTY Config, I set the Mark (and HAM Default) frequency at 2125 Hz, as I've always done. No r.f. output from the K3 with the PC (and interface) putting out the RTTY signal... The solution was to set the Mark (and HAM default) frequency to 915 Hz (170 Hz shift, of course!). That worked! I swear I NEVER touched the PITCH button, never mind that I had never changed the Mark frequency there...BUT, there it was, big as life, 915-170! Did this parameter change on its own from 2125 to 915, or did this change take place with FW updating? "Curioser and curiouser..." as Alice would say! 73, Bert, N4CW ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected]
This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
