The KX3 (and K3) bandwidth controls are with respect too the audio
frequency, not the RF frequency. So in LSB mode, for example, the
bandwidths move in opposite directions on the KX3 and PX3. In AM mode,
the bandwidth is mirrored about the carrier frequency.
Alan N1AL
On 12/23/2014 02:01 AM, JE0LFI wrote:
Hi
In AM mode,
When I specified the PBT to Low=0.0 and Hi=4.0, the cursor's low side(PBT I)
displayed in the left side of the center. And hi side(PBT II) displayed in
the right side of the center.
The band width of the cursor, looks like more than 4.0KHz across the center
frequency.
Is this correct?
73,
JE0LFI / Nakamura
#wish FixTrack mode and SYNC-AM mode
--
View this message in context:
http://elecraft.365791.n2.nabble.com/PX3-v1-16-Bug-Cursor-in-AM-mode-tp7596296.html
Sent from the Elecraft mailing list archive at Nabble.com.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
