Thanks Rich
your advice was perfect
also found the link I was looking for
http://www.n3me.net/pdf%20files/N1MM%20-%20Elecraft%20K3%20Setup%20Notes.pdf
David Moes
President: Peterborough Amateur Radio Club.
[email protected]
VE3DVY, VE3SD
On 1/1/2015 22:02, Richard Ferch wrote:
Re mode changes - in the N1MM Logger's Configurer window, under the
Mode Control tab, for Mode sent to radio for RTTY, set the listbox to
AFSK. If it is set to RTTY, the Logger will switch the K3 to FSK D.
Re PTT, there are many different ways to control PTT. If you are using
AFSK, you can let N1MM Logger do all the PTT control, either using RTS
on the same COM port you use for radio control, or by using software
commands, or by using a separate COM port, or from a Winkeyer (N1MM
Logger can use the Winkeyer's PTT output in all modes, not just CW).
If you opt for any of these methods, MMTTY's PTT & FSK port should be
set to NONE.
Alternatively, you can control PTT (and FSK, if you are using it) from
MMTTY on a separate COM port, in which case MMTTY needs to be
configured to use that port.
How you configure N1MM Logger depends on which method you are using
for PTT control. This is all described at
<http://n1mmplus.hamdocs.com/tiki-index.php?page=Digital+Setup&structure=N1MM+Logger+Documentation#Setting_Up_the_Configurer>.
73,
Rich VE3KI
VE3DVY wrote:
One issue is mode changes. when I am using MMTTY and N1MM it wants to
change the mode from AFSK to FSK when ever I change bands or select RTTY
mode from N1MM I have to press DATA MD and change it from FSK-d back to
AFSK A
also
Every time close MMTTY and open it from N1MM again it forgets that I am
using the COM-2 for PTT it reverts to NONE. All the other settings
like mark frequency seem to hold.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
