Thanks for clarifying that. It's not something that had bothered me, but I just observed it after Nakamura asked the question about the behaviour of the VFO with NB/NR. I had thought at first he meant it stopped the VFO completely, not just a short pause while displaying the parameters - which I am sure there are technical reasons for.
73 David Anderson GM4JJJ > On 3 Jan 2015, at 18:29, Wayne Burdick <[email protected]> wrote: > > When you're displaying noise blanker or or noise reduction parameters, etc., > the VFO is disabled. > > Wayne > N6KR > > ---- > http://www.elecraft.com > >> On Jan 3, 2015, at 1:11 AM, David Anderson <[email protected]> wrote: >> >> I observe this pause too. The main VFO does not move while the NR or NB >> setting display is showing. I am not sure if this was always like this or >> not. >> >> Perhaps someone with an earlier version of firmware would like to check and >> comment? >> >> 73 >> >> David Anderson GM4JJJ >> >>> On 2 Jan 2015, at 08:07, JE0LFI <[email protected]> wrote: >>> >>> Hi all, Happy New Year 2015! >>> >>> In version 2.27, when you turn on the NR or NB of KX3, will not move the >>> main dial. >>> >>> Is this a specification, or bug of v2.27? >>> >>> --- >>> >>> JE0LFI / Nakamura >>> >>> >>> ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
