Just finished a nice QSO on 40 meters and the right channel click using
NEW QSK seems to be completely gone (or so low my old ears can't detect
it). I set the 60 meter channels up in memories using the K3/KX3 memory
editor and tried running through the modes and used TUNE and ATU-TUNE
into a dummy load. They seem to work okay. I didn't put a signal on
the air as there were QSO's in progress on all the channels.
Channel hopping - My PX3 updates properly, changing modes and it works
on 2 meters with the transverter as well. I hooked up my SignaLink USB
and checked the EQ settings - they now auto-set to no EQ when DATA modes
are selected - Ran my HAL ST-8000 super RTTY AFSK modem through it and
same there on RTTY.
My testing shows everything is OK, but it's possible I missed something.
However, I'd put it up for Beta and get a wider range of testers for a
deeper perspective - I beat on it pretty hard, but there are some guys
out there that could break a steel beam without even trying - LOL.
Jim - W0EB
------ Original Message ------
From: "Wayne Burdick" <[email protected]>
To: "Steve Buroker" <[email protected]>; "Reed" <[email protected]>;
[email protected]; "Ron" <[email protected]>; "Ray Sills"
<[email protected]>; "Leroy Marion" <[email protected]>; "Art
Nienhouse" <[email protected]>; "Charles Powell" <[email protected]>;
"Jim Sheldon" <[email protected]>; "Greg Franklin" <[email protected]>;
"Hjalmar Duklæt" <[email protected]>; "Don Palmer"
<[email protected]>; "Randy Moore" <[email protected]>;
"Jean-François Ménard" <[email protected]>; "John
Oppenheimer" <[email protected]>; "[email protected] Quental"
<[email protected]>; "Darren Long" <[email protected]>; "Matt Zilmer"
<[email protected]>; "Gary - NC3Z" <[email protected]>; "Edouard
Lafargue" <[email protected]>; "Paul Locker" <[email protected]>;
"Sven Ladegast" <[email protected]>; "John and Rita Freitag"
<[email protected]>; "Rick Tavan N6XI" <[email protected]>; "ka5wrg"
<[email protected]>
Sent: 1/7/2015 9:39:16 PM
Subject: KX3 rev. 2.33: Improved NEW QSK mode, flat RX EQ in DATA modes
Hi all,
The attached KX3 field-test firmware is improved over the release I
sent most of you previously (2.32). NEW QSK mode should now produce
fewer receive artifacts while keying with AFX=DELAY. DATA mode RX EQ
should be completely flat.
Please give it a good workout, using as many bands, modes and features
as possible, as we'd like to go to beta with this rev if possible. See
release notes below, which include a proposed method of testing NEW QSK
vs. OLD QSK.
73,
Wayne
N6KR
* * *
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
