I am building a K1. On page 37, Alignment and test, Part 1, when I turn
on power I do not get the e27 display. The LED test was correct. The
LCD only shows a few vertical bars on the top half of the display. If I
tap a switch, the display goes blank. All resistance and voltage checks
up to this point are OK. I have gone back over the construction steps
and check soldering etc. Can't find anything wrong. Any suggestions?
---
This email is free from viruses and malware because avast! Antivirus protection
is active.
http://www.avast.com
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
