I did, it works....
With a Softrock-RX for 30 metres. The LO is an xtal on 40.5 MHz that
produces 10.125 MHz and that shows on the PX3 as 0Hz.
The real problem comes with the need to recalibrate te I/Q phase and
amplitude in order to have a good image rejection.
On -25 kHz I see the DDK9 teleprinter and on +20 kHz I see the average
bunch of data modes and in between: CW sigs.
For me it was merely "try and see what happens" for the KX3 obviously
rocks much better...
73,
Peter - PA0PJE
Op 2015-01-27 23:52 schreef Tom Blahovici:
Hi
It would not work properly as is. I think one would need to send information to
the px3 via the serial port to establish the centre frequency, markers, and
respond to qsy''s.etc. as well as react to requests coming from the px3.
Assuming these are standard api type commands it could be a possibility. Could
be a fun project.
Tom
va2fsq.com
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
