Lane,
I believe you want to ground them as shown in the manual. I built my K2
using the method of grounding on both sides. It has been a little while
since I built mine but I seem to recall reading somewhere that this is
an improvement over grounding to the top. Also if you add options such
as the KPA100, grounding to the side helps eliminate clearance issues
with other circuit boards.
Mike
KI0HA
On 1/31/2015 20:12, Lane wrote:
I'm at the point of grounding the X7-X11 crystals on page 54 of the K2
build manual and the instructions appear to be different than whats shown
on the K2 build photos on the elecraft site. The photos on the site show a
single side ground to top of crystal. Manual seems to state grounding on
both sides and slight up from board.
Without anyone going way out of their way to do this, would anyone happen
to have a photo of the proper grounding for these crystals?
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
